qmk-firmware/keyboards/idank/sweeq

Sweeq

Sweeq is a Ferris Sweep clone that uses diodes, instead of the latter's direct pin matrix.

The primary goal is to free up the SDA/SCL pins so they can be used by auxiliary devices such as a trackball, trackpoint or an OLED screen.

Other than the diode changes and the ability to use hotswap sockets, this keyboard is identical to the original Sweep.

• Keyboard Maintainer: @idank
• Hardware Supported: sweeq
• Hardware Availability: holykeebs

Make example for this keyboard (after setting up your build environment):

make idank/sweeq:default

Flashing example for this keyboard:

make idank/sweeq:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available